Home | Aluminum Alloy 1350 Data Sheet

Aluminum Alloy 1350 Data Sheet

See the full list of United Aluminum Alloys Here

Alloy Group: 1XXX

PRINCIPAL ALLOYING ELEMENT: Unalloyed Aluminum

Group: Purity of 99.5% or Greater

ALUMINUM ALLOY 1350 GENERAL DESCRIPTION:

1350 is widely used in applications where good electrical conductivity is required. It has an aluminum purity of 99.5% or purer with tight controls on certain impurities that could adversely affect conductivity.

TYPICAL CHEMISTRY LIMITS:

	Si	Fe	Cu	Mn	Mg	Cr	Zn	Ti	Others-Each	Others Total	Al Min
1350	0.1	0.4	0.05	0.05	–	0.01	0.05	–	0.03	0.10	99.50

Composition according to Aluminum Association.

TYPICAL MECHANICAL DATA:

The following typical properties are not guaranteed since in most cases they are average for various sizes and methods of manufacture and may not be exactly representative of any particular product or size. The data is intended for comparing alloys and tempers and should not be used for design purposes.

Source: Aluminum Standards & Data and United Aluminum data base

Alloy-Temper	Tensile Strength (ksi)	Yield Strength (ksi)	Elongation (%)
1350-O	12	4	34
1350-H14	16	14	3
1350-H19	27	24	2

Coil of Aluminum Alloy 1350 on a pallet.

Although this data has been designed by United Aluminum or taken from sources United Aluminum believes to be reliable, this data needs to be thoroughly evaluated and tested by technically skilled personnel before any use is made thereof. United Aluminum assumes no responsibility or liability for any use of this data, or with respect to the infringement of any patent, and no warranties are give or implied by United Aluminum. This information is not to be copied used in evidence, released for publication or passed to a third party without written permission from United Aluminum.